Perancangan Alat Manual Punch Orienteering dengan Metode Reverse Engineering

Seno, Yoga Mulia and -, Much. Djunaidi., ST., MT (2018) Perancangan Alat Manual Punch Orienteering dengan Metode Reverse Engineering. Skripsi thesis, Universitas Muhammadiyah Surakarta.

	PDF (NASKAH PUBLIKASI) NASKAH PUBLIKASI NEW.pdf Download (1MB)
	PDF (HALAMAN DEPAN) Cover.pdf Download (973kB)
	PDF (BAB I) BAB I.pdf Download (450kB)
	PDF (BAB II) BAB II.pdf Restricted to Repository staff only Download (334kB) | Request a copy
	PDF (BAB III) BAB III.pdf Restricted to Repository staff only Download (118kB) | Request a copy
	PDF (BAB IV) BAB IV.pdf Restricted to Repository staff only Download (1MB) | Request a copy
	PDF (BAB V) BAB V.pdf Restricted to Repository staff only Download (7kB) | Request a copy
	PDF (DAFTAR PUSTAKA) Daftar Pustaka.pdf Download (13kB)
	PDF (LAMPIRAN) LAMPIRAN.pdf Restricted to Repository staff only Download (3MB) | Request a copy
	PDF (SURAT PERNYATAAN PUBLIKASI) Surat Pernyataan Publikasi Ilmiah.pdf Restricted to Repository staff only Download (278kB) | Request a copy

Abstract

ABSTRACT The sport of orienteering doesn’t run optimally without a tool named manual punch. In fact, the necessary for manual punch as a major component in the competition are not offset by the availability of orienteering, which later became one of the obstacles faced by activists or organizers of orienteering in Indonesia. Based on these problems, then the products into the design on this research tool is the Manual Punch Orienteering is used as a marker for each control point in sports Orienteering. The making of product design tool Manual Punch begins by identifying the customer's needs. Methods used in the development of a Manual Punch this is by using the method of Reverse Engineering, the application of the science of ergonomics, Anthropometry data processing, then proceed with the design of software design using SolidWork. The results of design were obtained based on a descriptive analysis of the questionnaire and the interview is a product design that is comfortable, secure, and can remove plug on the nail hole with a total of 12 nail, with the curved upper body and flat-bottom body as well as the horizontal strap hole. The size of the tool based on Anthropometry data of the hand is the length of 100 mm, a width of 20 mm and 30 mm high. Keywords: Manual Punch, Orienteering, Reverse Engineering, The DESIGN of

Item Type:	Karya ilmiah (Skripsi)
Uncontrolled Keywords:	Manual Punch, Orienteering, Reverse Engineering, DESIGN, Perancangan
Subjects:	T Technology > TS Manufactures
Divisions:	Fakultas Teknik > Teknik Industri
Depositing User:	YOGA MULIA SENO
Date Deposited:	15 Aug 2018 10:23
Last Modified:	15 Aug 2018 10:26
URI:	http://eprints.ums.ac.id/id/eprint/66743

Actions (login required)

View Item