Simulasi Cup Drawing Untuk Menghindari Cacat Wrinkling Dan Thinning Dengan Menggunakan Software Autoform R2

Muhammad Effendi, Fendi (2016) Simulasi Cup Drawing Untuk Menghindari Cacat Wrinkling Dan Thinning Dengan Menggunakan Software Autoform R2. Skripsi thesis, Universitas Muhammadiyah Surakarta.

[img] PDF (Naskah Publikasi)
NASKAH PUBLIKASI.pdf

Download (1MB)
[img] PDF (Halaman Depan)
HALAMAN DEPAN.pdf

Download (1MB)
[img] PDF (BAB I)
BAB I.pdf

Download (210kB)
[img] PDF (BAB II)
BAB II.pdf
Restricted to Repository staff only

Download (603kB)
[img] PDF (BAB III)
BAB III.pdf
Restricted to Repository staff only

Download (209kB)
[img] PDF (BAB IV)
BAB IV.pdf
Restricted to Repository staff only

Download (606kB)
[img] PDF (BAB V)
BAB V.pdf
Restricted to Repository staff only

Download (86kB)
[img] PDF (Daftar Pustaka)
DAFTAR PUSTAKA.pdf

Download (186kB)
[img] PDF (Lampiran)
LAMPIRAN.pdf
Restricted to Repository staff only

Download (1MB)
[img] PDF (Surat Pernyataan Publikasi Ilmiah)
SURAT PERYATAAN PUBLIKASI ILMIAH.pdf
Restricted to Repository staff only

Download (80kB)

Abstract

Simulations carried out to reduce the pace of trial and error so as to avoid the mistakes of products and can reduce the overall cost of production. The purpose of this simulation is to determine the effect of variations of blank holder force and coefficient of friction against wrinkling and thinning defects in the process of cup drawing. Simulations carried out using software AutoForm R2 and tools that are used to follow the standards NumiSheet 2014 Benchmark 4 of wrinkling during cup drawing. There are five variations of blank holder force used in this simulation 37N, 57N, 77N, 97N and 117N and four variations of the coefficient of friction of 0.05, 0.15, 0.25, and 0.35. Plate material used is aluminum plate with a thickness of 0.32 mm and a zinc plate with a thickness of 0.30 mm. Results analysis of simulation data either on an aluminum plate and zinc plate material is impaired wrinkling when there is an increase blank holder force and coefficient of friction. While thinning that occurs is inversely proportional to the results of wrinkling, thinning percentage even higher due to rising blank holder force and coefficient of friction. Analysis of test material failure with forming limit diagram shows that all the cups are in a safe condition and free from fracture.

Item Type: Karya ilmiah (Skripsi)
Uncontrolled Keywords: Simulation, Cup Drawing, Wrinkling, Thinning
Subjects: T Technology > TS Manufactures
Divisions: Fakultas Teknik > Teknik Mesin
Depositing User: Unnamed user with username d200100025
Date Deposited: 01 Feb 2016 08:41
Last Modified: 01 Feb 2016 08:41
URI: http://eprints.ums.ac.id/id/eprint/40598

Actions (login required)

View Item View Item