Analisa Pembentukan Mangkuk Bahan Aluminium Tebal 0.88 mm dengan Metode Metal Spinning Variasi Nose Radius Roller (R4, R5.5 Dan R6.5)

Prasetya, Heru and -, Bambang Waluyo F, ST. MT (2020) Analisa Pembentukan Mangkuk Bahan Aluminium Tebal 0.88 mm dengan Metode Metal Spinning Variasi Nose Radius Roller (R4, R5.5 Dan R6.5). Skripsi thesis, Universitas Muhammadiyah Surakarta.

	PDF (Naskah Publikasi) naspub heru.pdf Download (830kB)
	PDF (Halaman Depan) COVER.pdf Download (577kB)
	PDF (Bab I) BAB I.pdf Download (21kB)
	PDF (Bab II) BAB II.pdf Restricted to Repository staff only Download (771kB) | Request a copy
	PDF (Bab III) BAB III.pdf Restricted to Repository staff only Download (1MB) | Request a copy
	PDF (Bab IV) BAB IV.pdf Restricted to Repository staff only Download (568kB) | Request a copy
	PDF (Bab V) BAB V.pdf Restricted to Repository staff only Download (8kB) | Request a copy
	PDF (Daftar Pustaka) DAFTAR PUSTAKA.pdf Download (6kB)
	PDF (Lampiran) lampiran.pdf Restricted to Repository staff only Download (185kB) | Request a copy
	PDF (Surat Pernyataan Publikasi) pernyataan publikasi.pdf Restricted to Repository staff only Download (236kB) | Request a copy

Abstract

The utilization of metal is used for daily life can not be avoided anymore. One of the method for metal forming is metal spinning method. This method is a forming of metal sheet with high spinning speed. Mandrel and Roller usually are used for this method. Subject of the research is the application of nose radius roller R4, R5.5 R6.5 againts the surface roughness with metal spinning method. Product of the research is Aluminium bowl, after the product is finished and the surface roughness will be analyzed later with roughness test equipment and it is splitted into two for the thickness distribution measurement make micrometer. From the roughness of surface measurement was obtained average results for nose radius roller R4 was 0.734 m, nose radius roller R5.5 is 0.539 m and for nose roller R6.5 was 0.370 m. It can be concluded the highest surface roughness was the application of nose radius roller R4 and the lowest surface roughness was R6.5. The thickness distribution became more thin to the edge.

Item Type:	Karya ilmiah (Skripsi)
Uncontrolled Keywords:	Metal spinning,cup, surface roughness, thickness distribution, nose radius roller.
Subjects:	T Technology > TJ Mechanical engineering and machinery
Divisions:	Fakultas Teknik > Teknik Mesin
Depositing User:	HERU PRASETYA
Date Deposited:	22 Feb 2020 06:26
Last Modified:	22 Feb 2020 06:26
URI:	http://eprints.ums.ac.id/id/eprint/81607

Actions (login required)

View Item