Perencanaan Dan Pembuatan Prototipe Sistem Kemudi Kendaraan Empat Roda Dengan Sudut Hingga 90˚

Ichsan, Fani Nur Fadhila and , Agus Dwi Anggono, ST, M.Eng, Ph.D and , Ir. Sarjito, MT, Ph.D (2017) Perencanaan Dan Pembuatan Prototipe Sistem Kemudi Kendaraan Empat Roda Dengan Sudut Hingga 90˚. Thesis thesis, Universitas Muhammadiyah Surakarta.

This is the latest version of this item.

[img] PDF (Bab I)
BAB I.pdf

Download (437kB)
[img] PDF (Bab II)
BAB II.pdf
Restricted to Repository staff only

Download (1MB)
[img] PDF (Bab III)
BAB III.pdf
Restricted to Repository staff only

Download (646kB)
[img] PDF (Bab IV)
BAB IV.pdf
Restricted to Repository staff only

Download (1MB)
[img] PDF (Bab V)
BAB V.pdf
Restricted to Repository staff only

Download (90kB)
[img] PDF (Daftar Pustaka)
DAFTAR PUSTAKA.pdf

Download (212kB)
[img] PDF (Halaman Depan)
HALAMAN DEPAN.pdf

Download (850kB)
[img] PDF (Pernyataan Publikasi Ilmiah)
SURAT PERNYATAAN PUBLIKASI KARYA ILMIAH.pdf
Restricted to Repository staff only

Download (149kB)
[img] PDF (Naskah Publikasi)
NASKAH PUBLIKASI.pdf

Download (1MB)

Abstract

Today's technological advances and developments are very rapid, especially in the automotive industry. Many new technologies applied to vehicles with various functions such as security upgrades and technologies that make it easier for drivers to operate and control vehicles. The purpose of this study is to analyze the mechanism of the steering system with 90˚ turn angle that can be use on all-terrain vehicles and all-wheeled vehicles. Research method begins by preparing all the necessary tools and components then made assembly planning. Followed by modeling or design using CATIA V5 software and assembled after all component design is complete. From the assembled component in CATIA V5, Von Misses stress and displacement analysis performed on components with torque variation of 250 Nm, 280 Nm, and 300 Nm and continues with motion simulation using CATIA V5 until the result showed no collision between components and then made the prototype at the technical workshop. The result of the material structure analysis shows that the von Misses stress does not exceed the yield strength of steel material properties that is 2.5+008 N/m 2 and the displacement is very small below 1 mm which is in the safe category for next motion simulation. Motion simulation does not show any significant collisions between components, there is only a small friction because all parts of the component rotate. In the end, the prototype successfully made according to the initial design.

Item Type: Thesis (Thesis)
Uncontrolled Keywords: CATIA, prototipe, simulation, steering system, von mises
Subjects: T Technology > TJ Mechanical engineering and machinery
Divisions: Fakultas Pasca Sarjana > Magister Teknik Mesin
Depositing User: Unnamed user with username u100140014
Date Deposited: 01 Nov 2017 06:04
Last Modified: 01 Nov 2017 06:10
URI: http://eprints.ums.ac.id/id/eprint/56730

Available Versions of this Item

  • Perencanaan Dan Pembuatan Prototipe Sistem Kemudi Kendaraan Empat Roda Dengan Sudut Hingga 90˚. (deposited 01 Nov 2017 06:04) [Currently Displayed]

Actions (login required)

View Item View Item