Analisa Pengaruh Variasi Suhu Plastik Terhadap Cacat Warpage Dari Produk INjection Molding berbahan PolyProphylene (PP)

Zulianto, Dwi and , Bambang Waluyo F.,ST., MT and , Ir Pramuko Ilmu P, MT. (2015) Analisa Pengaruh Variasi Suhu Plastik Terhadap Cacat Warpage Dari Produk INjection Molding berbahan PolyProphylene (PP). Diploma thesis, Universitas Muhammadiyah Surakarta.

[img] PDF (Naskah Publikasi)
Naskah publikasi.pdf

Download (552kB)
[img] PDF (Halaman Depan)
SAMPUL PENGESAHAN.pdf

Download (871kB)
[img] PDF (Bab I)
BAB I A.pdf

Download (19kB)
[img] PDF (Bab II)
BAB II A.pdf
Restricted to Repository staff only

Download (459kB) | Request a copy
[img] PDF (Bab III)
BAB III new.pdf
Restricted to Repository staff only

Download (4MB) | Request a copy
[img] PDF (Bab IV)
BAB IV A.pdf
Restricted to Repository staff only

Download (6MB) | Request a copy
[img] PDF (Bab V)
BAB V A.pdf
Restricted to Repository staff only

Download (10kB) | Request a copy
[img] PDF (Daftar Pustaka)
daftar pustaka.pdf

Download (10kB)
[img] PDF (Lampiran)
lampiran full new.pdf
Restricted to Repository staff only

Download (1MB) | Request a copy
[img] PDF (pernyataan publikasi ilmiah)
pernyataan.pdf
Restricted to Repository staff only

Download (440kB) | Request a copy

Abstract

Plastic is the material began to dominate replace metal based materials. This is because plastic is known as a versatile material, is easily formed (formability), lightweight, unbreakable stainless, corrosion resistant, more cheap and many of the advantages of plastic in the injection molding production also has disabled warpage problems, among others. Warpage is defective product forms such irregularities bent or twisted. This caused one of which is the temperature of injection. This study was done to determine the percentage of warpage that occurs due to temperature variations when the injection of plastic material into the mold polyphropylene. With variations in temperature, which is between 138°C, 140 °C, 145 °C, 150 °C, 155 °C and 160 °C. From the analysis of defect measurements found that the specimen results warpage of plastic injection of the material polyphropylene with 138°C temperature, 140 °C, 145 °C, 150 °C is not the discovery of defects that occur warpage. At a temperature of 160 °C is found defective greatest warpage is the smallest amount of warpage 3.10, and the largest 4.90 mm with an area of 26.06 Cm 2 and the smallest (33.17%) and the biggest area of 32.40 Cm 2 (41.24%). Optimal temperature in this study was 145 °C. Keywords: injection molding, solidwork, dial indicators, temperature plastic, warpage.

Item Type: Karya ilmiah (Diploma)
Uncontrolled Keywords: injection molding, solidwork, dial indicators, temperature plastic, warpage.
Subjects: T Technology > TJ Mechanical engineering and machinery
Divisions: Fakultas Teknik > Teknik Mesin
Depositing User: DWI ZULIANTO
Date Deposited: 12 Feb 2016 03:38
Last Modified: 13 Oct 2021 03:04
URI: http://eprints.ums.ac.id/id/eprint/41085

Actions (login required)

View Item View Item